Masalah yang dibahas pada Tugas Akh

Masalah yang dibahas pada Tugas Akhir ini dibatasi pada simulasi pengendali pintu gerbang dan garasi dengan penggeraknya. Spesifikasi alat yang akan disimulasikan adalah :
1. Prinsip kerja pengirim sinyal berfrekuensi 35 MHz, penerima sinyal
berfrekuensi 35 MHz pula.
2. Saklar sinyal (1-3) volt untuk mengendalikan pintu gerbang dan garasi.
3. Jarak jangkauannya hanya berkisar kurang lebih 20 meter dan kemampuan motor dc
12 dengan beban pintu kurang lebih 120 gr.

Results (English) 1:

The problem that is discussed in this final Task is limited to simulation controllers a gateway and garage with its driving. Specifications of tools that will be simulated are:1. Working principles of the sender of the signal frequency signal receiver 35 MHz, 35 MHz-frequency anyway.2. Switch signal (1-3) volts to control the gate and garage.3. Within its scope only range of approximately 20 meters and the ability of dc motor 12 with a load of door approximately 120 gr.

Results (English) 2:

The issues discussed in this final project is limited to simulation control gate and the garage with the driving. Specifications tool that will be simulated are:
1. The working principle 35 MHz frequency signal sender, receiver signal
frequency 35 MHz as well.
2. Switch signal (1-3) volts to control gate and the garage.
3. The distance range is only about less than 20 meters and the ability dc motor
12 with a load of approximately 120 gr door.